Product Details
The Merit M-8S from Furman is an AC power sequencing solution for your rack mount system. Install an M-8S in your rack and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load. There is also an additional unswitched single outlet on the front of the unit for convenience.
- Features:
-
- Standard level AC protection and filtering
- Six configurable delayed rear panel outlets (in 3 groups) two unswitched rear panel outlets and one front panel unswitched outlet
- Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only)
- All settings and configurations available on rear panel
- 15 amp rating
Product Highlights
- Power Sequencing
- Noise Filtration
- Surge Protection
- 9 Total Outlets
- 15 Amp Rating
- "Protection OK" Indicator
- Spaced Outlets for Bulky Adapters
Specifications:
Maximum Output Current: 15 amps, 120 VAC (Thermal breaker) Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug AC Receptacles: • Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R
• Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex),
• 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)Standard level AC Surge Protection : Merit Class (sacrificial) Spike Protection Mode : Line to neutral, zero ground leakage Max Continuous Operating Voltage : 130V RMS Max Clamp Voltage : 500 Volts Peak Peak Impulse Current : 12,000 Amps Energy Rating (2 X 820μS) : 225 Joules AC Filtering : Standard level Pi LCR Filter Noise Attenuation : >26dB, 100 Khz to 1 MHz Operating Temperature Range : 5C (40F) to 40C (105F) degrees Humidity Range : <90% rH (Relative Humidity) Rocker Switch : Front panel, Sequence (ON, OFF) Thermal Circuit Breaker : Front panel, push to reset Front Panel Indicators : Delay 1, Delay 2, Delay 3, Power, Protection OK Rear Panel DIP Switches : 12V Mode On/Off, GND Mode On, Momentary/Maintained Potentiometer : Rear panel, time calibration fine tune delay adjust Remote Terminal : +5-30VDC In, 12VDC (12mA) Out Remote Terminal : Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring) Dimensions : 19"L x 8.75"D x 1.75"H – ANSI 1RU Weight : 7 lbs. Power Consumption : 5 Watts Safety Agency : C/CSA/US
